Enhance Your Career With Available Preparation Guide for FCSS_NST_SE-7.6 Exam
Get Special Discount Offer of FCSS_NST_SE-7.6 Certification Exam Sample Questions and Answers
Fortinet FCSS_NST_SE-7.6 Exam Syllabus Topics:
| Topic | Details |
|---|---|
| Topic 1 |
|
| Topic 2 |
|
| Topic 3 |
|
| Topic 4 |
|
| Topic 5 |
|
NEW QUESTION # 21
Consider the scenario where the server name indication (SNI) does not match either the common name (CN) or any of the subject alternative names (SAN) in the server certificate.
Which action will FortiGate take when using the default settings for SSL certificate inspection?
- A. FortiGate closes the connection because this represents an invalid SSL/TLS configuration.
- B. FortiGate uses the CN information from the Subject field in the server certificate.
- C. FortiGate uses the first entry listed in the SAN field in the server certificate.
- D. FortiGate uses the SNI from the user's web browser.
Answer: B
NEW QUESTION # 22
Refer to the exhibit.
An IPsec VPN tunnel is dropping, as shown by the debug output.
Analyzing the debug output, what could be causing the tunnel to go down?
- A. The tunnel drops during rekey negotiation.
- B. Dead Peer Detection is not receiving its acknowledge packet.
- C. The tunnel drops after the timer expires.
- D. Phase 2 drops but Phase 1 is up.
Answer: B
NEW QUESTION # 23
Exhibit.
Refer to the exhibit, which shows the output of a diagnose command.
What can you conclude about the debug output in this scenario?
- A. There is a natural correlation between the value in the FortiGuard-requests field and the value in the Weight field.
- B. Servers with a negative TZ value are less preferred for rating requests.
- C. FortiGate used 64.26.151.37 as the initial server to validate its contract.
- D. The first server provided to FortiGate when it performed a DNS query looking for a list of rating servers, was 121.111.236.179.
Answer: A
NEW QUESTION # 24
Refer to the exhibit, which shows the output of a debug command.
Which two statements about the output are true? (Choose two.)
- A. The interlace is part of the OSPF backbone area.
- B. In the network connected to port4, two OSPF routers are down.
- C. There are a total of five OSPF routers attached to the vorz4 network segment
- D. One of the neighbors has a router ID of 0.0.0.4.
Answer: A,B
NEW QUESTION # 25
Refer to the exhibit, which shows the output o! the BGP database.
Which two statements are correct? (Choose two.)
- A. The first four prefixes are being advertised using a legacy route advertisement.
- B. The advertised prefix of 10.20.30.0'24 was configured using the network command.
- C. The output shows all prefixes advertised by all neighbors as well as the local router.
- D. The advertised prefix of 10.20.30.0'24 is being advertised through the redistribution of another routing protocol.
Answer: B,C
NEW QUESTION # 26
Refer to the exhibit.
Which three pieces of information does the diagnose sys top command provide? (Choose three.)
- A. The miglogd daemon would be on top of the list, if the administrator pressed m on the keyboard.
- B. The diagnose sys top command has been running for 18 minutes.
- C. The cmdbsvr process is occupying 2.4% of the total user memory space.
- D. If the neweli daemon continues to be in the R state, it will need to be manually restarted.
- E. The miglogd daemon is running on CPU core ID 0.
Answer: A,C,E
NEW QUESTION # 27
An administrator wants to capture encrypted phase 2 traffic between two FotiGate devices using the built-in sniffer.
If the administrator knows that there Is no NAT device located between both FortiGate devices, which command should the administrator run?
- A. diagnose sniffer packet any 'udp port 500'
- B. diagnose sniffer packet any 'udp port 4500'
- C. diagnose sniffer packet any 'lp proto 50'
- D. diagnose sniffer packet any 'ah'
Answer: C
NEW QUESTION # 28
Refer to the exhibit, which shows the output of the command get router info ospf neighbor.
To what extent does FortiGate operate when looking at its OSPF neighbors? (Choose two.)
- A. Neighbor 0.0.0.18 is the designated router (DR).
- B. The local FortiGate is the DR.
- C. The local FortiGate has at least one interface that participates in a broadcast network.
- D. The local FortiGate has at least one interface that participates in a point-to-point network.
Answer: C,D
Explanation:
The command on this slide shows a summary of the statuses of all the OSPF neighbors. For each neighbor, it displays the adjacency state and if it is a DR, a BDR, or neither (DROther) Pagina 362 Enterprise_Firewall_7.
2_Study. - Point-to-point networks contain only two peers, one at each end of a point-to-point link - Broadcast networks (multi-access) support more than two attached routers. They also support sending messages to multiple recipients (broadcasting). Pagina 365 Enterprise_Firewall_7.2_Study. In any multi-access network there is one DR and one BDR. Pagina 439 Network_Security_Support_Engineer_7.4_Study FULL/- This represents a point-to-point network
NEW QUESTION # 29
Refer to the exhibit, which shows a partial output from the get router info routing-table database command.
The administrator wants to configure a default static route for port3 and assign a distance of 50 and a priority of 0.
What will happen to the port1 and port2 default static routes after the port3 default static route is created?
- A. The port2 default static route will be injected into the forwarding information base (FIB).
- B. The port1 default static route will be injected into the FIB.
- C. Neither of the routes shown in the output will be injected into the FIB.
- D. Both default static routes shown in the output will be injected into the FIB.
Answer: A
NEW QUESTION # 30
What are two reasons you might see iprope_in_check() check failed, drop when using the debug flow?
(Choose two.)
- A. Packet was dropped because of policy route misconfiguration.
- B. Packet was dropped because of traffic shaping.
- C. VIP or IP pool misconfiguration.
- D. Trusted host list misconfiguration.
Answer: C,D
NEW QUESTION # 31
Which two statements about Security Fabric communications are true? (Choose two.)
- A. FortiTelemetry and Neighbor Discovery both operate using TCP.
- B. By default, the downstream FortiGate establishes a connection with the upstream FortiGate using TCP port 8013.
- C. The default port for Neighbor Discovery can be modified.
- D. FortiTelemetry must be manually enabled on the FortiGate interface.
Answer: B,D
NEW QUESTION # 32
Exhibit.
Refer to the exhibit, which shows the output of diagnose automation test.
What can you observe from the output? (Choose two.)
- A. The automation stitch test failed but the HA failover was successful.
- B. An HA failover occurred.
- C. The test was unsuccessful.
- D. The automation stitch test is not being logged.
Answer: C,D
NEW QUESTION # 33
Exhibit.
Refer to the exhibit, which shows the output of get system ha status.
NGFW-1 and NGFW-2 have been up for a week.
Which two statements about the output are true? (Choose two.)
- A. If no action is taken, the primary FortiGate will leave the cluster because of the current sync status.
- B. If FGVM...649 is rebooted. FGVM...650 will become the primary and retain that role, even after FGVM...649 rejoins the cluster.
- C. If port 7 becomes disconnected on the secondary, both FortiGate devices will elect itself as primary.
- D. If a configuration change is made to the primary FortiGate at this time, the secondary will initiate a synchronization reset.
Answer: B,C
NEW QUESTION # 34
Refer to the exhibit, which shows the output of a BGP debug command.
What can you conclude about the router in this scenario?
- A. All of the neighbors displayed are part of a single BGP configuration on the local router with the neighbor-range set to a value of 4.
- B. The router 100.64.3.1 needs to update the local AS number in its BGP configuration in order to bring up the 8GP session with the local router.
- C. The BGP session with peer 10.127.0.75 is up.
- D. An inbound route-map on local router is blocking the prefixes from neighbor 100.64.3.1.
Answer: C
NEW QUESTION # 35
Refer to the exhibit, which shows a partial web filter profile configuration.
The URL www.dropbox.com is categorized as File Sharing and Storage.
Which action does FortiGate take if a user attempts to access www.dropbox.com?
- A. FortiGate blocks the connection, based on the FortiGuard category-based filter configuration.
- B. FortiGate blocks the connection as an invalid URL.
- C. Based on the Web Content filter configuration, access to www.dropbox.com would be exempted.
- D. Based on the URL Filter configuration, FortiGate allows the connection.
Answer: D
NEW QUESTION # 36
What are two functions of automation stitches? (Choose two.)
- A. You can create automation stitches to run diagnostic commands and attach the results to an email message when CPU or memory usage exceeds specified thresholds.
- B. You can set an automation stitch configured to execute actions in parallel to insert a specific delay between actions.
- C. You can configure automation stitches to execute actions sequentially by taking parameters from previous actions as input for the current action.
- D. You can configure automation stitches on any FortiGate device in a Security Fabric environment.
Answer: A,C
NEW QUESTION # 37
Refer to the exhibit, which shows the modified output of the routing kernel.
Which statement is true?
- A. The default static route through port2 is in the forwarding information base.
- B. The egress interface associated with static route 8.8.8.8/32 is administratively up.
- C. The BGP route to 10.0.4.0/24 is not in the forwarding information base.
- D. The default static route through 10.200.1.254 is not in the forwarding information base.
Answer: C
NEW QUESTION # 38
Refer to the exhibit, which shows a partial output of a real-time LDAP debug.
What two conclusions can you draw from the output? (Choose two.)
- A. FortiOS performs a bind to the LDAP server using the user's credentials.
- B. FortiOS is performing the second step (Search Request) in the LDAP authentication process.
- C. The user was found in the LDAP tree, whose root is TAC.ottawa.fortinet.com.
- D. FortiOS collects the user group information.
Answer: B,C
NEW QUESTION # 39
Which statement about IKEv2 is true?
- A. IKEv1 and IKEv2 share the concept of phase1 and phase2.
- B. Both IKEv1 and IKEv2 share the feature of asymmetric authentication.
- C. IKEv1 and IKEv2 use same TCP port but run on different UDP ports.
- D. IKEv1 and IKEv2 have enough of the header format in common that both versions can run over the same UDP port.
Answer: D
NEW QUESTION # 40
Exhibit.
Refer to the exhibit, which shows a partial web fillet profile configuration.
Which action does FortiGate lake if a user attempts to access www. dropbox. com, which is categorized as File Sharing and Storage?
- A. FortiGate exempts the connection, based on the Web Content Filter configuration.
- B. FortiGate blocks the connection, based on the FortiGuard category based filter configuration.
- C. FortiGate blocks the connection as an invalid URL.
- D. FortiGate allows the connection, based on the URL Filter configuration.
Answer: B
NEW QUESTION # 41
Exhibit.
Refer to the exhibit, which shows a partial output of diagnose hardware aysinfo memory.
Which two statements about the output are true? (Choose two.)
- A. There are 98908 kB o! memory that will never be used.
- B. The I/O cache, which has 641364 kB of memory allocated to it.
- C. The value indicated next to the inactive heading represents the currently unused cache page.
- D. The user space has 708880 kB of physical memory that is not used by the system.
Answer: A,C
NEW QUESTION # 42
Refer to the exhibit, which shows the output of diagnose sys session list.
If the HA ID for the primary device is 0, what happens if the primary fails and the secondary becomes the primary?
- A. The session state is preserved but the kernel will need to re-evaluate the session because NAT was applied.
- B. Traffic for this session continues to be permitted on the new primary device after failover, without requiring the client to restart the session with the server.
- C. The session will be removed from the session table of the secondary device because of the presence of allowed error packets, which will force the client to restart the session with the server.
- D. The secondary device has this session synchronized; however, because application control is applied, the session is marked dirty and has to be re-evaluated after failover.
Answer: B
NEW QUESTION # 43
Refer to the exhibits.
An administrator Is expecting to receive advertised route 8.8.8.8/32 from FGT-A. On FGT-B, they confirm that the route is being advertised and received, however, the route is not being injected into the routing table.
What is the most likely cause of this issue?
- A. FGT-B is configured with a prefix list denying the 8.8.8.8/32 network to be injected into the routing table.
- B. A batter route to the 8.8.8.8/32 network exists in the routing table.
- C. The administrator has misconfigured redistribution of routes on FGT-A.
- D. FGT-8 is configured with a distribution list denying the 8.8.8.8/32 network to be injected into the routing table.
Answer: A
NEW QUESTION # 44
......
Updated FCSS_NST_SE-7.6 Dumps Questions Are Available For Passing Fortinet Exam: https://www.testpassking.com/FCSS_NST_SE-7.6-exam-testking-pass.html
New FCSS_NST_SE-7.6 Dumps For Preparing Fortinet Certified Solution Specialist Certified Fortinet Exam Well: https://drive.google.com/open?id=1mgEShj04qduT4QJ0nXUkbhTeuHFzuY5G